|
| |
TM 9-2320-360-34-1
(4)
Remove four remaining screws (1) and
lockwashers (2) from clutch end cover (3).
Discard lockwashers.
WARNING
Clutch end cover is under spring
pressure. Loosen nuts slowly and
evenly
until
spring
tension
is
relieved. Failure to do so may cause
injury to personnel.
(5)
Loosen two nuts (6) on threaded rods (4)
and remove clutch end cover (3) from
clutch adapter (5).
(6)
Remove two nuts (6) and clutch end cover
(3) from two threaded rods (4).
(7)
Remove two threaded rods (4) from clutch
adapter (5).
(8)
Remove preformed packing (7) from
clutch end cover (3). Discard preformed
packing.
(9)
Remove spring (8) from clutch adapter (5).
(10)
Remove bearing (9) from shaft (10).
(11)
Remove thrust ring (11) from clutch drive
gear (12).
(12)
Disconnect two air lines (13) from fittings
(14).
17-31
|
