|
| |
TM 9-2320-360-34-1
(6)
Install steering shaft no. 3 carrier bearing
(8) on frame rail (2) with two screws (9)
and new locknuts (10). Torque to 44 lb-ft
(60 Nm).
(7)
Remove lifting device from winch platform
(5).
(8)
Route air hose no. 2762 (11), right wire
harness (12), and grommet (13) through
winch platform (5).
(9)
Install cushion clip (14) on right wire
harness (12) and winch platform (5) with
screw (15) and new locknut (16).
WARNING
Adhesive-sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid injury or death, keep away from
open fire and use in well-ventilated
area. If adhesive-sealant gets on skin
or clothing, wash immediately with
soap and water.
CAUTION
Only
apply
adhesive-sealant
to
threads that contact nut.
(9.1)
Coat middle threads of bulkhead fitting
(16.1) with adhesive-sealant.
(9.2)
Install bulkhead fitting (16.1) on winch
platform (5) with nut (16.2).
(9.3)
Install hose no. 2001 (16.3) and hose no.
20 (16.4) on bulkhead fitting (16.1).
17-11
|
