|
| |
TM 9-2320-360-34-1
(3)
Remove four nuts (6) and lockwashers (7)
from
two
U-bolts
(8).
Discard
lockwashers.
(4)
Position floor jack (1) under center of axle
(2).
(5)
Raise floor jack (1) and axle (2) 1 in. (2.54
cm) off spring (9).
(6)
Support axle (2) with jackstand (5).
(7)
Remove two U-bolts (8) and spring shoe
(10) from spring (9).
NOTE
Support, but do not lift, spring.
(8)
Position floor jack (1) under spring (9).
(9)
Remove nut (11) and lockwasher (12)
from
spring
lockpin
(13).
Discard
lockwasher.
CAUTION
Do not strike directly on spring
lockpin. Locknut should be partially
threaded on spring lockpin before
striking. Failure to comply may
damage spring lockpin.
(10)
Tap spring lockpin (13) out of spring link
(14).
WARNING
Keep hands clear of pin and spring
when removing pin. Failure to
comply may result In serious Injury
to personnel.
(11)
Remove pin (15) from spring link (14) and
spring (9).
15-3
|
