|
| |
TM 9-2320-360-20-1
TEE BOX TEST
(1)
Remove screw and locknut from lower yoke of top steering
shaft. Discard locknut.
(2)
Remove yoke from top tee box shaft.
(3)
Remove screw and locknut from yoke on front steering shaft.
Discard locknut.
(4)
Remove yoke from front tee box shaft.
(5)
Remove screw and locknut from yoke on rear steering shaft.
Discard locknut.
(6)
Remove yoke from rear tee box shaft.
(7)
Turn top tee box shaft to check for binding Replace tee box
(para 13-8) if it fails to turn smoothly or if It binds when top
shaft is turned.
(8)
Align key on rear tee box shaft with slot In steering shaft yoke.
(9)
Install yoke on rear tee box shaft with screw and new locknut.
(10) Align key on front tee box shaft with slot in steering shaft
yoke.
(11) Install yoke on front tee box shaft with screw and new locknut
(12) Align key on top tee box shaft with slot In steering shaft yoke.
(13) Install yoke on top tee box shaft with screw and new locknut.
STEERING REDUCTION GEAR
TEST
(1)
Remove screw and locknut from yoke
of input shaft. Discard locknut.
(2)
Remove yoke from Input shaft.
(3)
Remove screw and locknut from yoke
on output shaft. Discard locknut.
(4)
Remove yoke from output shaft.
(5)
Turn input shaft to check for binding
Replace steering reduction gear (para
13-12) if it fails to turn smoothly or if It
binds when input shaft is turned .
(6)
Align key on output shaft with slot in
steering shaft yoke.
(7)
Install yoke on output shaft with screw
and new locknut.
(8)
Align key on input shaft with slot in
steering shaft yoke
(9)
Install yoke on input shaft with screw
and new locknut
Change 2 2-916.1 (2-916.2 blank)
|
