|
| |
TM 9-2320-360-20-1
TEE BOX TEST
(1)
Remove screw and locknut from lower yoke of top steering
shaft. Discard locknut.
(2)
Remove yoke from top tee box shaft.
(3)
Remove screw and locknut from yoke on front steering shaft
Discard locknut.
(4)
Remove yoke from front tee box shaft.
(5)
Remove screw and locknut from yoke on rear steering shaft
Discard locknut.
(6)
Remove yoke from rear tee box shaft.
(7)
Turn top tee box shaft to check for binding Replace tee box
(para 13-8) if it fails to turn smoothly or if it binds when top
shaft is turned.
(8)
Align key on rear tee box shaft with slot in steering shaft yoke.
(9)
Install yoke on rear tee box shaft with screw and new locknut.
(10) Align key on front tee box shaft with slot in steering shaft yoke.
(11) Install yoke on front tee box shaft with screw and new locknut.
(12) Align key on top tee box shaft with slot in steering shaft yoke.
(13) lnstall yoke on top tee box shaft with screw and new locknut.
NOTE
Refer to steering
hydraulic hose
diagram in front of
this troubleshooting
section for steering
hose locations
Check front steering gear, steering
hoses, and fittings for leaks or damage.
Check front steering gear
mounting for damage.
2-893
|
