TM 9-2320-360-20-1 TRANSDUCER VOLTAGE TEST Table 2-13 Volts PSI (plus/minus 0.2 volts) 75 3.5 70 3.3 60 2.9 NOTE Tire  pressures  must  be  between  75  psi  (517  kPa) before beginning test to measure complete range of transducer voltage output. STE/ICE  Test  #50  is  used  to  monitor  pressures  at porting block 50 2.5 (1) Remove hose no 2102 and elbow from porting block. 40 2.0 (2) Install STE/ICE adapter and 0-1000 psi (0-6895 kPa) pressure 30 1.7 transducer on porting block 20 1.3 (3) Set CTI controller to EMERGENCY setting (TM 9-2320-360-10) 20 1.3 NOTE CTI  wiring  harness  must  remain  installed  to  controller and power manifold when performing this test (4) Place positive (+) probe of multimeter on white transducer wire (5) Place negative (-) probe of multimeter on known good ground (6) Start engine (TM 9-2320-360-10) (7) Move CTI switch to ON position (TM 9-2320-360-10) (8) Press CTI START button (TM 9-2320-360-10) (9) Record transducer voltage when porting block pressure reaches values shown in Table 2-13 (10)   Shut off engine (TM 9-2320-360-10) (11)   Remove STE/ICE pressure transducer and adapter from porting block (12)   Install elbow and air hose no 2102 on porting block POWER MANIFOLD VOLTAGE TEST NOTE Tire  pressures  must  be  75  psi (517 kPa) before beginning test to  measure  correct  transducer voltage output. CTI wiring harness must remain   installed   to   controller and power manifold     when performing this test (1) Place positive (+) probe of multimeter on pin 7. wire no 1062 (white), at controller (2) Place negative (-) probe of multimeter on known good ground (3) Start engine (TM 9-2320-360-10) (4) Move CTI switch to ON position (TM 9-2320-360-10) (5) Press CTI START button (TM 9-2320-360-10) and look for 3 5-4 volts on multimeter (6) Shut off engine (TM 9-2320-360-10) 2-869