|
| |
TM 9-2320-360-20-1
WARNING
·
Batteries must be disconnected
before
tightening
any
connections. Failure to comply
may result in injury to personnel.
·
Remove all jewelry such as rings,
dog tags, bracelets, etc. If
jewelry
contacts
electrical
terminals a direct short may
result in an instant heating of
tools, damage to equipment, and
CONTINUITY TEST
injury to personnel.
(1) Disconnect wiring from components at each
CAUTION
end of wire.
Batteries must be disconnected before
(2) Set multimeter to ohms position.
tightening any connections. Failure to
NOTE
comply may result in damaged
equipment.
A reading of infinity
indicates an open circuit.
Check wire no. 1129 from PTO indicator to
PTO oil pressure sending unit for loose
(3) Connect multimeter leads to each end of
connections or damage.
wire and check multimeter for continuity.
NOTE
A reading of other than
infinity indicates a grounded
wire.
(4) Remove multimeter lead from one end of
wire and connect to chassis ground.
Change 2 2-701 (2-702 blank)
|
