|
| |
TM 9-2320-360-20-1
CTI SIGNAL GENERATOR
TEST
(1)
Remove CTI signal generator
(para 20-7).
NOTE
Ends of CTI signal
generator should
be square, not
rounded off.
(2)
Inspect ends of CTI signal
generator for damage or worn
parts.
(3)
Turn one end of generator while
checking to see if other end turns.
(4)
Install CTI signal generator
(para 20-7).
SPEEDOMETER CABLE CHECK
(1)
Remove speedometer cable from angle
drive.
(2)
Remove speedometer cable from
speedometer adapter.
NOTE
Ends of speedometer
cable should be square,
not rounded off.
(3)
Inspect ends of speedometer cable for
damage or worn parts.
(4)
Turn one end of speedometer cable
while assistant checks other end
(5)
Install speedometer cable on
speedometer adapter.
SPEEDOMETER ANGLE DRIVE
CHECK
(1)
Remove speedometer angle drive
(para 20-5).
NOTE
Ends of speedometer
angle drive should be
square, not rounded
off.
(2)
Inspect ends of speedometer angle
drive for damage or worn parts
(3)
Turn one end of speedometer angle
drive while checking to see if other end
turns.
(4)
Install speedometer angle drive
({para 20-5).
2-619
|
