|
| |
TM 9-2320-360-20-1
WARNING
· Capacitor Inside strobe-type beacon light
assembly may contain high voltage. Ensure
light has been turned off for at least five
minutes before servicing. Failure to comply
may result in Injury to personnel.
· Jewelry can catch on equipment and cause
injury or short across electrical circuit and
cause severe burns or electrical shock.
Remove rings, bracelets, watches,
necklaces, and any other jewelry before
working around HET Tractor.
NOTE
HET M1070's are equipped with either a
rotating or strobe type beacon light Rotating
beacons have two light bulbs, strobe
beacons have one.
Check beacon light for burned out bulb.
WIRE NO. 1029 VOLTAGE
TEST
(1)
Turn ENGINE switch to ON
position.
(2)
Place beacon light switch in the on
position.
(3)
Place positive (+) probe of
multimeter on wire no 1029 at
beacon.
(4)
Place negative (-) probe of
multimeter on ground and look for
10-14 volts on multimeter.
(5)
Place beacon light switch in the off
position.
(6)
Turn ENGINE switch to OFF
position.
Change 3 2-603
|
