| |
TM 9-2320-360-20-1
Check neutral safety switch and receptacle
for loose connections or damage.
NEUTRAL SAFETY
SWITCH TEST
(1)
Disconnect neutral safety switch
from receptacle at transmission
shift linkage.
(2)
Set multimeter to ohms position.
(3)
Place positive (+) probe of
multimeter on terminal C at
neutral safety switch.
(4)
Place negative (-) probe of
multimeter on terminal E at
neutral safety switch, and check
multimeter for continuity.
(5)
Connect neutral safety switch to
receptacle if there is continuity
between terminals C and E.
Check ground wire no. 1435 from
neutral safety switch to ground for
loose connections and damage.
Change 2 2-383 (2-384 and 2-385 blank)
|