TM 9-2320-360-20-1 NEUTRAL SAFETY SWITCH CIRCUIT TEST CAUTION ENGINE switch must be positioned to OFF to perform this test Failure to comply may result in damage to test equipment. NOTE Relay can be pulled out of socket slightly to provide easier access for test. (1) Turn ENGINE switch to OFF. (2) Set multimeter to ohms position. (3) Place positive (+) probe of multimeter on wire no. 1458 at NEUTRAL relay. (4) Place negative (-) probe of multimeter on ground and check multim eter for continuity. IGNITION CIRCUIT TEST NOTE ENGINE switch must be positioned and held to START to perform this test. (1) Turn and hold ENGINE switch to START. (2) Place positive (+) probe of multimeter on wire no. 1871 at NEUTRAL relay (3) Place negative (-) probe of multimeter on ground and look for 10-14 volts on multimeter. (4) Turn ENGINE switch to OFF. WIRE NO. 1021 TEST NOTE ENGINE switch must be positioned and held to START to perform this test. (1) Turn and hold ENGINE switch to START. (2) Place positive (+) probe of multimeter on wire no. 1021 at NEUTRAL relay (3) Place negative (-) probe of multimeter on ground and look for 22-28 volts on multimeter. (4) Turn ENGINE switch to OFF. (5) Inspect wire no. 1021 between neutral relay and engine switch if no voltage is measured Change 2  2-375