|
| |
TM 9-2320-360-20-1
Check
connectors
at
TRS
(both
harness side and SRS side) for
damage, bent, corroded, and unseated
pins or sockets, or bad contacts.
(1)
Turn ENGINE switch OFF.
(2)
Reconnect all connectors.
(3)
Turn ENGINE switch ON.
(4)
Start and run engine until,
CHECK ENGINE LIGHT
comes ON for 1 minute.
(5)
Stop engine and read
historical codes.
WARNING
Jewelry can catch on equipment and
cause injury or short across electrical
circuit and cause severe burns or
electrical
shock.
Remove
rings.
bracelets, watches, necklaces, and any
other jewelry before working around HET
Tractor.
CAUTION
Use jumper wire only between terminals
indicated. Failure to comply may result in
damage to DDEC components or wiring.
(1)
Turn ENGINE switch OFF.
(2)
Connect all connectors.
(3)
Wire 6-pin power connector to a fully
charged battery (12 volt).
(4)
Connect to ECM and try to start engine.
2-225
|
