|
| |
TM 9-2320-360-20-1
NOTE
The following flow chart should only be
used if DDEC troubleshooting was started
on p. 2-80 and you were referred here.
CAUTION
Use jumper wire only between terminals
indicated. Failure to comply may result in
damage to DDEC components or wiring.
(1)
Turn ENGINE switch OFF.
(1.1) Remove right inner fender (para
16-34).
(2)
Disconnect OPS connector and
install a jumper wire between
sockets B and C of the OPS
harness connector.
(2.1) Click on “Alarms Clear” to clear
alarms screen.
(3)
Turn ENGINE switch ON and read
active codes. If active codes 35 or
36 do not exist start and run
engine until either active Code 35
or 36 appears or until engine
temperature (Mode 18 OIL TEMP
on DDR) is greater than 140 F
(60 C) for more than 1 minute.
(1)
Turn ENGINE switch OFF.
(2)
Inspect terminals at the
OPS connectors (sensor
side and harness side) for
damage; bent, corroded and
unseated pins or sockets.
Change 2 2-195
|
