|
| |
TM 9-2320-360-20-1
CAUTION
Use jumper wire only between terminals
indicated. Failure to comply may result in
damage to DDEC components or wiring.
CONTINUITY TEST
(1)
Install a jumper wire between
sockets A and B of the TPS
harness connector.
(2)
Read resistance between sockets
D2 and C3 on vehicle harness
connector.
Check ECM and terminals at ECM vehicle
harness connector (both ECM and harness
side) for damage; bent, corroded, and
unseated pins and sockets.
CONTINUITY TEST
(1)
Turn ENGINE switch OFF
and disconnect vehicle
harness connector at ECM.
(2)
Read resistance between
sockets A and C on TPS
harness connector.
2-153
|
