|
| |
TM 9-2320-360-20-1
CAUTION
Use jumper wire only between
terminals indicated. Failure to
comply may result in damage to
DDEC components or wiring.
NOTE
The following flow chart should only be
used
if
DDEC
troubleshooting
was
started on p. 2-82 and you were referred
here.
(1)
Turn ENGINE switch OFF.
(2)
Disconnect CLS module and install a
jumper between sockets D and C of CLS
harness connector.
(3)
Attempt to start and run engine at idle.
(4)
Read active codes.
(5)
Stop engine.
CONTINUITY TEST
(1)
Turn ENGINE switch OFF and
disconnect vehicle harness
connector.
(2)
Read resistance between socket
H3 on vehicle harness connector
and a good ground.
2-135
|
