|
| |
TM 9-2320-360-20-1
CONTINUITY TEST
(1) Turn ENGINE switch OFF.
(2) Disconnect vehicle harness connector at ECM.
(3) Read resistance between sockets A and B on
the vernier control harness connector.
CAUTION
Use jumper wire only between
terminals indicated Failure to
comply may result in damage to
DDEC components or wiring.
CONTINUITY TEST
(1) Install a jumper wire between sockets A and
B of Vernier Control harness connector.
(2) Read resistance between sockets D1
and C3 on vehicle harness connector.
2-111
|
