|
| |
TM 9-2320-360-20-1
2-23. STORAGE MAINTENANCE PROCEDURES (CONT)
(4)
Axle extended storage.
CAUTION
To avoid overfilling, drain oil before installing additive. Failure to comply may
cause damage to equipment.
(a)
Drain amount of oil from axle that is equal to quantity of additive being added.
(b)
Add 1.7 pt (0.8 L) VCI-326 vapor corrosion inhibitor (MIL-P-46002B) (or equivalent) to axles no 1,2, 3, and
4.
(c)
Add 2.6 oz (76 ml) VCI-326 vapor corrosion inhibitor (MIL-P-46002B) (or equivalent) to planetary wheel
ends of axles no 1, 2, 3, and 4.
(d)
Drive vehicle approximately 1 mile (1.6 km) to mix additive with the axle oil.
(e)
If additional storage time is required, repeat steps (a) thru (c) at yearly intervals.
(5)
Winch extended storage. None required.
(6)
Transfer Case extended storage.
CAUTION
To avoid overfilling, drain oil before installing additives. Failure to comply may
cause damage to equipment.
(a)
Drain amount of oil from transfer case that is equal to quantity of additive being added.
(b)
Add .5 pt (0.25 L) VCI-326 vapor corrosion inhibitor (MIL-P-46002B) or equivalent to transfer case.
(c)
If vehicle can be driven, drive vehicle approximately 1 mile (1.6 km) to mix additive. If vehicle cannot be
driven, shift transfer case to neutral, start engine (TM 9-2320-360-10), with parking brake applied shift transmission thru
all gear selections.
WARNING
Ensure transfer case is cool before proceeding. Failure to comply may result in
injury to personnel.
(d)
When transfer case is cool enough to touch, seal breather with moisture proof tape.
(e)
Coat all exposed, unpainted surfaces with preservative grease such as petrolatum (MIL-C-11796 grade 2)
or equivalent.
(f)
If additional storage time is required, repeat step (b) at yearly intervals.
(7)
Winch hydraulic system extended storage.
CAUTION
To avoid overfilling, drain oil before installing additives. Failure to comply may
cause damage to equipment.
(a)
Drain amount of oil from winch hydraulic reservoir that is equal to the quantity of additive being added.
(b)
Add 8.5 qt (8 L) VCI-326 vapor corrosion inhibitor (MIL-P-46002B) or equivalent to winch hydraulic
reservoir.
(c)
Operate all winches.
(1)
Pay out and then pay in passenger side and drivers side main winches approximately 10 ft (3 m).
Repeat this procedure two times.
(2)
Pay out and then pay in auxiliary winch approximately 10 ft (3 m). Repeat this procedure two times.
(d)
If additional storage time is required, repeat steps (a) and (b) at yearly intervals.
2-992 Change 3
|
