|
| |
TM 9-2320-360-20-1
Check cable hold down air lines and air
line no 2771 from cable hold down to air
manifold for leakage or damage.
Refer to para 17-3 to adjust pressure
regulator valve.
CONTROL VALVE TEST
(1)
Start engine (TM 9-2320-360-10) and run
until AIR PRESS gage indicates at least 70
psi (483 kPa)
(2)
Remove air line from cable hold down
control valve outlet port
(3)
Connect pressure gage to cable hold down
control valve outlet port
(4)
Position CABLE HOLD DOWN control to
ON (TM 9-2320-360-10) and check reading
on pressure gage. Pressure gage should
read 70 psi (483 kPa).
(5)
Replace cable hold down control valve read
(para 17-7) if pressure gage does not 70 psi
(483 kPa)
(6)
Install air line on cable hold down control
valve outlet port if it operates properly.
Change 2 2-957
|
