|
| |
TM 9-2320-356-BO
Procedural Steps:
1.
Clean the hole thoroughly.
2.
Smooth out sharp edges.
3.
Sandpaper the edges of the hole.
4.
Cut a piece of screen 1 inch larger than the hole.
5. Apply a thin coat of epoxy to the edges of the hole.
6. Lay the screen over the hole and add another layer of epoxy around the edges.
Let it dry approximately 20 to 30 minutes.
7.
Cut a patch the same size as the screen from an aluminum can.
8. Coat the entire screen with epoxy and lay the metal patch over the screen.
9.
Apply epoxy over the patch.
10. Let dry for 2 to 3 hours.
11. Record the BDAR action taken.
When the mission is completed, as soon as
practicable, repair using standard maintenance procedures.
5-18
|
