|
| |
TM 9-2320-356-BD
Option 2:
Replacement of Long Damaged Tube Section.
1.
A long damaged section of metal tubing should be replaced with a new section of
metal tubing.
Use a piece of rubber hose and two hose clamps at each end to
install the replacement section.
2.
Record the BDAR action taken.
When the mission is completed, as soon as
practicable, repair using standard maintenance procedures.
Option 3:
Heat Shrink Tubing (Short Damaged Lengths).
1.
Cut out damaged section of tubing; deburr and clean ends.
2.
Select a piece of shrink tubing with inside diameter equal to the outside
diameter of the tube.
Cut shrink tubing 2 inches longer than the piece of removed
tubing.
3.
Slip the shrink tubing 1 inch over each end of the cut installation.
4.
Heat the portion of the heat-shrink tubing that is over the metal tubing and
seal the connection.
5.
Record the BDAR action taken.
When the mission is completed, as soon as
practicable, repair using standard maintenance procedures.
3-22
|
