TM  9-2320-356-BD Table   14-1. Tube   and   Hose   Specifications NOTE High-pressure   tube   and   hose   repairs   may   be   used to   fix   low-pressure   conduits. Conduit Conduit Pressure size length Damage Number requirements inches inches r e s u lt Location 1 2 3 4 5 6 7 8 9 10 Hose, high-pressure 2.0   ID 1.0   ID 1.0 OD 44.0 38.0 15.0 68.0 68.0 22.0 80.0 48.0 77.0 77.0 Immediate   loss   of entire   system   power Reservoir   to   pump Hose, high-pressure Immediate   loss   of entire   system   power Pump   to   gondola Tube, high-pressure Immediate   loss   of entire   system   power Gondola   to   direc- tional    control valves Hose, high-pressure 1.0   ID Immediate    traverse power   loss.   No   ef- fect   if   not   operated. Swing   motor   to traverse   control valve Hose, high-pressure 1.0   ID Immediate    traverse power   loss.   No   ef- fect   if   not   operated. Swing   motor   to traverse   control valve Hose, high-pressure 1.0   ID Immediate   boom   exten- sion   power   loss.   No effect   if   not operated. Extension    control valve   to   side   of gondola 1.0   ID Immediate   boom   exten- sion   power   loss.   No effect   if   not operated. Extension   cylin- der   to   extension control   valve Hose, high-pressure 1.0   ID Immediate   boom   exten- sion   power   loss.   No effect   if   not operated. Side   of   gondola to   extension c y l i n d er Hose, high-pressure 1.0   ID 1.0   ID Immediate   loss   of winch   power. No   ef- fect   if   not   operated. Winch   control valve   to   crane hinge Hose high-pressure Immediate   loss   of winch   power. No   ef- fect   if   not   operated. Winch   control valve   to   crane hinge Hose, high-pressure 14-20