|
| |
TM 9-2320-356-BD
Section II.
ELECTRICAL COMPONENTS
8-4. GENERAL
Electrical circuits contain switches and protection devices. Bypassing a failed
switch or protective device is a rapid repair but may create more damage.
The
circuit must be checked for shorts before bypassing a protective device.
8-5. NEUTRAL SAFETY SWITCH DEFECTIVE
General Information:
Engine starter will not energize.
This procedure will allow the engine to be
started with the shifting lever in any position.
Limitations:
o None
Personnel/Time Required:
o 1 soldier
o 15 minutes
Materials/Tools:
o E l e c t r i c a l t a p e
o Duct tape
o Bandaid
o Shoelace
Procedural Steps:
1.
Locate neutral safety switch.
2.
Disconnect both wires.
3.
Slide protective insulation boots back on the wires to expose the electrical
connectors.
4.
Wrap the two electrical connectors together with tape or shoelace.
5. Record the BDAR action taken.
When the mission is completed, as soon as
practicable, repair using standard maintenance procedures.
8-3
|
