Installation Procedure -807640668

TM 9-2320-312-24-2

Truck Engine

Disassembly and Assembly Section

1. Fasten Tooling (A) and a hoist to flywheel housing

(1).

2. Remove twelve bolts (2) and bolt (3) that fastens

the flywheel housing to the cylinder block.

g00650171

Illustration 140

g00612738

Illustration 139

3. Remove four bolts (4) that fasten the engine oil

pan to flywheel housing (1). Remove flywheel

housing (1). The weight of flywheel housing (1)

is approximately 25 kg (55 lb).

Installation Procedure

Table 30

g00612738

Illustration 141

Required Tools

Part

2. Fasten Tooling (A) and a hoist to flywheel

Tool

Part Description

Qty

Number

housing (1). Position flywheel housing (1) on the

cylinder block. The weight of flywheel housing

138-7573

Link Bracket

(1) is approximately 25 kg (55 lb). Install four

bolts (4) that fasten the engine oil pan to flywheel

NOTICE

housing (1).

Keep all parts clean from contaminants.

3. Install twelve bolts (2) and one bolt (3) that

Contaminants may cause rapid wear and shortened

fastens the flywheel housing to the cylinder

component life.

block.

4. Remove Tooling (A) and the hoist from flywheel

Note: Ensure that the mating surface of the flywheel

housing (1).

housing and the mounting face of the cylinder block

are thoroughly clean. Inspect the gasket of the

5. Check the flywheel housing runout. Refer to

engine oil pan for damage. Replace the gasket, if

the Systems Operation/Testing and Adjusting,

necessary.

"Flywheel and Flywheel Housing".

1. Apply 1U-8846 Sealant to the entire mounting

End By:

face of the flywheel housing prior to installation.

a. Install the flywheel. Refer to Disassembly and

Assembly, "Flywheel - Install".