Click here to make tpub.com your Home Page

Page Title: Test Step 5. Check the Switch Circuit
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

383
TM 9-2320-312-24-2
Troubleshooting Section
"PTO Switch ON"
Result 6
RESULT 7 The ET Kickout Status displays the
Repair: Perform the following diagnostic
following result:
procedure:
"Neutral"
Troubleshooting, "PTO Switch Circuit - Test"
RESULT 8 The ET Kickout Status displays the
STOP.
following result:
Result 7
"No Engine Speed"
Repair: Perform the following diagnostic
procedure:
RESULT 9 The ET Kickout Status displays the
following result:
Troubleshooting, "Neutral Switch Circuit - Test"
"Ser Switch Timeout"
STOP.
"Resume Switch Timeout"
Result 8
Results:
Repair: Perform the following diagnostic
Result 1 Proceed to Test Step 5.
procedure:
Result 2
Troubleshooting, "Engine Speed/Timing Sensor
Circuit - Test"
Repair: Perform the following diagnostic
procedure:
STOP.
Result 9
Troubleshooting, "Cruise Control Switch Circuit -
Test"
Repair: Perform the following diagnostic
procedure:
STOP.
Result 3
Troubleshooting, "Cruise Control Switch Circuit
- Test".
Repair: Perform the following diagnostic
procedure:
STOP.
Test Step 5. Check the Switch Circuit.
Troubleshooting, "Powertrain Data Link Circuit -
Test"
Table 191
STOP.
Table for Status of Service Brake Pedal
Position (Switch 1)
Result 5
Condition of Switch
Switch Status
Circuit
Circuit
Repair: Perform the following diagnostic
procedure:
Terminal 45 is Open.
ON
Open
Terminal 45 connected
Troubleshooting, "Clutch Pedal Position Switch
OFF
Shorted
to terminal 5.
Circuit - Test"
A. Turn the ignition key switch to the OFF position.
STOP.
Result 5
B. Fabricate a jumper wire 100 mm (4 inch) long.
Crimp a Deutsch Pin to both ends of the wires.
Repair: Perform the following diagnostic
C. Disconnect vehicle harness connector P1 from
procedures:
the ECM.
Troubleshooting, "Vehicle Speed and
D. Connect a breakout T to ECM Connector J1 and
Speedometer Circuit - Test"
connect P1 to the breakout T.
STOP.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business