Click here to make tpub.com your Home Page

Page Title: Test Step 5. Check the Switch Circuit for the ECM
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

335
TM 9-2320-312-24-2
Troubleshooting Section
"PTO Switch ON"
Repair: Perform the following diagnostic
procedure:
RESULT 7 The ET Kickout Status displays the
following result:
Troubleshooting, "PTO Switch Circuit - Test"
"Clutch"
STOP.
Result 7
RESULT 8 The ET Kickout Status displays the
following result:
Repair: Perform the following diagnostic
"No Engine Speed"
procedure:
Troubleshooting, "Clutch Pedal Position Switch
RESULT 9 The ET Kickout Status displays the
Circuit - Test"
following result:
"Ser Switch Timeout"
STOP.
"Resume Switch Timeout"
Result 8
Repair: Perform the following diagnostic
Results:
procedure:
Result 1 Proceed to Test Step 5.
Troubleshooting, "Engine Speed/Timing Circuit -
Result 2
Test"
Repair: Perform the following diagnostic
STOP.
procedure:
Result 9
Troubleshooting, "Cruise Control Switch Circuit -
Test"
Repair: Perform the following diagnostic
procedure:
STOP.
Troubleshooting, "Cruise Control Switch Circuit
Result 3
- Test".
Repair: Perform the following diagnostic
STOP.
procedure:
Test Step 5. Check the Switch Circuit for
the ECM.
Troubleshooting, "Powertrain Data Link Circuit -
Test"
Table 180
STOP.
Neutral Switch Input Status Table
Condition of Switch
Result 4
Switch Status
Circuit
Circuit
Repair: Perform the following diagnostic
Terminal 62 is open.
OFF
Open
procedure:
Terminal 62 connected
ON
Closed
to +battery.
Troubleshooting, "Service Brake Pedal Position
(Switch 1) Circuit - Test"
A. Turn the ignition key switch to the OFF position.
STOP.
B. Fabricate a jumper wire 100 mm (4 inch) long.
Result 5
Crimp a Deutsch pin to both ends of the wires.
Repair: Perform the following diagnostic
C. Disconnect vehicle harness connector P1 from
procedure:
the ECM.
Troubleshooting, "Vehicle Speed Circuit - Test"
D. Connect a breakout T to ECM connector J1 and
connect P1 to the breakout T.
STOP.
Result 6

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business