Click here to make tpub.com your Home Page

Page Title: Table 176. Idle Kickout Status Table
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

329
TM 9-2320-312-24-2
Troubleshooting Section
Table 176
Idle Kickout Status Table
ET
Meaning or Possible Cause
Troubleshooting
Intermittent engine speed signal or lost
Refer to Troubleshooting, "Engine
"No Engine Speed"
engine speed signal.
Speed/Timing Circuit - Test".
The Cruise/Idle On/Off switch is turned OFF
Refer to Troubleshooting, "Cruise Control
or the switch circuit has an open circuit
Switch Circuit - Test".
"Switch Turned Off"
condition.
The cruise control pause switch is
Refer to Troubleshooting, "Powertrain Data
"Cruise Control PAUSE
depressed or there is an illegal message on
Link Circuit - Test".
Switch"
the J1939 data link.
The service brake pedal is depressed or
Refer to Troubleshooting, "Service Brake
"Brake Pedal Depressed"
the service brake switch circuit has an open
Pedal Position (Switch 1) Circuit - Test".
circuit condition.
The clutch pedal is depressed or the
Refer to Troubleshooting, "Clutch Pedal
clutch pedal switch circuit has an open
Position Switch Circuit - Test".
"Clutch Pedal Depressed"
circuit condition. Also, the switch could be
incorrectly adjusted.
The vehicle speed has exceeded the Idle
Refer to Troubleshooting, "Vehicle Speed
"Vehicle Speed Limit"
Vehicle Speed Limit or the vehicle speed
Circuit - Test" if a problem with the signal
signal is erratic or intermittent.
exists.
The transmission is not in neutral or the
Proceed with the test procedure.
"Neutral"
transmission neutral switch circuit has an
open circuit condition.
The PTO On/Off switch is turned ON or the
Refer to Troubleshooting, "PTO Switch
PTO On/Off switch circuit has a short circuit
Circuit - Test".
"PTO Switch On"
condition.
Idle set speed has not been enabled since
Operate the vehicle in the Idle mode in order
"No Occurrence"
the ECM has been powered up.
to create the problem again.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business