FEATURES OF VOLUME I (WORK PACKAGE-FORMATTED MANUAL) -807640025

TM 9-2320-312-24-2

FEATURES OF VOLUME I (WORK PACKAGE-FORMATTED MANUAL)

Because the major assembly groupings used in this manual do not correspond to military function group codes (FGC) and

are unfamiliar to the soldier, maintenance tasks in Volume I include in their initial setups the following information:

MAC Reference (e.g., MAC Group 160)

RPSTL Reference (e.g., RPSTL Group 160, Figure 003)

This information will assist the user to locate appropriate MAC guidance and repair parts for the component being main-

tained.

WARNINGs, CAUTIONs, NOTEs, subject headings, and other important information are highlighted in BOLD print as a

visual aid.

WARNING

A WARNING indicates a hazard that may result in death or serious injury.

CAUTION

A CAUTION is a reminder of safety practices or directs attention to usage practices that may cause damage

to equipment.

NOTE

A NOTE is a statement containing information that will make the procedures easier to perform.

Statements and words of particular interest may be printed in CAPITAL LETTERS to create emphasis.

Within a procedural step, reference may be made to another work package in this volume of the manual or to another vol-

ume of this manual or another manual. These references indicate where you should look for more complete information.

If you are told: "Fill hydraulic reservoir (WP 0129 00)", go to work package 0129 00 in Volume 1 of this manual

for instructions on filling the hydraulic reservoir.

If you are told: "Raise fifth wheel (TM 9-2320-312-10)", go to TM 9-2320-312-10 for complete instructions on

raising the fifth wheel. Use the Table of Contents or alphabetical Index in TM 9-2320-312-10 to find the procedure.

If you are told "Repair transmission torque converter (Group 070 Commercial Service Manuals)", go to Group 070

in the Commercial Service Manuals (Volume 3) to find the procedure.

Illustrations are placed after, and as close to, the procedural steps to which they apply. Callouts placed on the art may be

text or numbers, or both.

Numbers located at the lower right corner of the art (e.g. 376-001, 376-002, etc.) are art control numbers and are used for

tracking purposes. Disregard these numbers.

Dasher leader lines used in illustrations indicate that called-out items are not visible in the view depicted (i.e. they are

located within or behind the structure). In Lubrication Charts (WP 0008 00, Unit PMCS Introduction) and in Unit PMCS

(WP 0009 00), dashed leader lines indicate a lubrication that is required on both sides of the equipment.

Technical instructions include metric units as well as standard units. For your reference, a Metric Conversion Chart is

located on the inside back cover of the manual.