 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
FIFTH WHEEL HYDRAULIC LIFT CYLINDER REPLACEMENT - CONTINUED
0158 00
INSTALLATION - CONTINUED
12.
Have an assistant operate hydraulics to extend cylinder (TM 9-2320-312-10).
13.
While continuing to support cylinder (3), move small stage end of cylinder into position at fifth wheel frame sub-assem-
bly (8).
14.
Apply a thin coat of grease to pivot pin (7) and to bearing surface at small stage end of cylinder (3).
NOTE
Ensure pivot pin is installed so that end with hole is oriented to outside of vehicle.
15.
Use a brass drift to install pivot pin (7) through cylinder (3) and fifth wheel frame sub-assembly (8). Install screw (6)
and new locknut (9).
16.
Remove sling and lifting device from cylinder (3).
7
7
3
8
3
8
6
9
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death to
personnel.
17.
Position overhead lift above fifth wheel and attach lifting chains to frame sub-assembly in front of fifth wheel. Take up
slack in chains.
0158 00-16
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals