 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
FIFTH WHEEL MAINTENANCE - CONTINUED
0157 00
REMOVAL - CONTINUED
5
6
3
3
4
5
8,9,10
7
7
8,9,10
CLEANING AND INSPECTION
1.
Clean rubber bushings in detergent and water solution. Wipe dry with a clean rag.
WARNING
Dry cleaning solvent MIL-PRF-680 Type III is an environmentally compliant and low toxic material. How-
ever, it may be irritating to the eyes and skin. The use of protective gloves and goggles is suggested. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
2.
Use dry cleaning solvent to remove dirt, debris, and grease from all other removed components. Clean thoroughly both
fifth wheel mounting area and mounting area on fifth wheel frame sub-assembly. Wipe dry with a clean rag.
3.
Inspect for wear, cracks, breaks, bends or other damage.
4.
Inspect rubber bushings for wear, deterioration, tears or other damage.
5.
Replace all damaged parts.
REPAIR
Refer to Group 160 Commercial Service Manuals to repair fifth wheel.
INSTALLATION
NOTE
When fifth wheel is installed, grease fitting on each side of fifth wheel must align with hole in bearing.
1.
Position bearing (9) and rubber bushing (10) on each side of fifth wheel frame sub-assembly (7). Secure with two bear-
ing stop blocks (8).
2.
Install grease fitting (4) on each side of fifth wheel (3).
3.
Apply a thin coat of grease to bearing surfaces of two pins (5).
0157 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals