 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
AIR CONDITIONING SYSTEM HOSE REPLACEMENT - CONTINUED
0156 00
REMOVAL - CONTINUED
CAUTION
DO NOT disconnect or connect refrigerant fittings using only one wrench. Hold one fitting in place using a
wrench and turn other fitting with a second wrench. Failure to follow this caution may damage fittings.
2.
Disconnect each end of hose (1).
CAUTION
Water and dirt can damage refrigerant system. Five minutes of not being capped is the limit for any hose or
component. DO NOT blow shop air through refrigerant hoses. Shop air is wet (humid).
3.
Cap opening where hose (1) was disconnected.
NOTE
Remove and discard tiedown straps as required. Use new tiedown straps on installation.
4.
Remove hose (1) from vehicle.
5.
Remove conduit (2) from hose (1).
1
2
INSTALLATION
NOTE
Any time air conditioning system refrigerant is evacuated, replace receiver-drier.
1.
Replace receiver-drier (WP 0154 00).
2.
Install conduit (2) to hose (1).
3.
Position hose (1) to vehicle.
4.
Lubricate new o-ring (3) with refrigerant oil and install to hose (1).
5.
Apply loctite to male threads (4) and connect each end of hose (1). Tighten connections in accordance with WP 0136 00.
0156 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals