 |
|||
|
|
|||
|
Page Title:
RETURNING CAB TO 45-DEGREE TILT POSITION - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-312-24-1
PLACING CAB IN 90-DEGREE TILT POSITION - CONTINUED
0147 00
RETURNING CAB TO 45-DEGREE TILT POSITION - CONTINUED
When cab reaches balance point, continue to slowly tilt and lower cab. Stop when cab is fully lowered.
3.
4.
Remove overhead lift, clevises, chains, and wood cribbing.
5.
Connect safety prop (28) to underside of cab with pin (31), two washers (30), and new cotter pin (29).
6.
Connect tilt cylinder (27) to underside of cab with pin (25), washer (26), and new cotter pin (24).
27
25
26
24
31
28
30
29
7.
Place battery disconnect switch to ON position.
8.
Tilt cab to 45-degree position using cab tilt pump. Ensure cab is securely supported by safety prop (TM 9-2320-312-10).
9.
Cut tiedown strap and release lower steering column from attachment to horn. Discard tiedown strap. Align matchmarks
and install yoke (17) of lower steering column to shaft of steering gear (18). Install screw (15) and nut (16). Tighten nut
to 26 lb-ft (35 Nm).
17
15 16
MATCHMARKS
18
0147 00-12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals