 |
|||
|
|
|||
|
Page Title:
DISASSEMBLY AND ASSEMBLY INSTRUCTIONS |
|
||
| ||||||||||
|
|
 TM 9-2320-312-24-1
GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0134 00
DISASSEMBLY AND ASSEMBLY INSTRUCTIONS
1.
Keep major components together whenever possible and practical.
2.
Tag hoses, electrical wires, cables, and harnesses to identify them and aid during installation.
3.
Keep related parts together for identification purposes.
4.
Temporarily install attaching hardware such as screws, bolts, washers, and nuts to prevent loss.
5.
Only disassemble to the point of the problem.
6.
Ensure that parts are clean and lubricated before assembly.
REPAIR INSTRUCTIONS
CAUTION
Before welding, the following components must be disconnected to avoid damage to electronic components:
Engine ECU
Transmission ECU
Auxiliary arctic heater (if equipped)
For more information on welding procedures and precautions, refer to decal under right-side instrument
panel inside cab.
1.
Repair castings, forgings, and machined parts using the following instructions:
a.
Repair minor cracked castings or forgings in accordance with TM 9-237.
b.
Repair minor damage to machined surfaces with an abrasive cloth dipped in detergent (Item 23, WP 0165 00).
c.
Replace any deeply nicked machined surface that could affect the assembly operation.
d.
Repair minor damage to threaded capscrew holes with thread tap of same size to prevent cutting oversize.
2.
After repair, thoroughly clean all parts to prevent dirt, metal chips or other foreign material from entering any working
parts.
LUBRICATION INSTRUCTIONS
NOTE
Refer to TM 9-2320-312-10 and to Unit PMCS (WP 0008 00 and WP 0009 00) for detailed, illustrated
instructions on proper lubrication. Some general practices to remember:
1.
Use the correct lubricant.
2.
Keep lubricants clean.
3.
Clean all fittings prior to lubrication.
4.
Lubricate clean disassembled and new parts to prevent rust.
APPLICATION OF ADHESIVES AND SEALING COMPOUNDS
1.
General. Adhesives are recommended in some tasks to ensure and strengthen seals. Sealing compounds are used to seal
parts against moisture. The following information describes their correct use and application.
Adhesive. Adhesive provides a seal against leakage and a resistance to loosening when used in the assembly of
2.
threaded, slip-fitted or press-fitting parts. Always use grade of adhesive specified and never use when other retaining
means are provided, such as lockwires, lockwashers, lockplates, and fasteners.
0134 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals