PUMP ASSEMBLY REMOVAL - CONTINUED - TM-9-2320-312-24-10734

TM 9-2320-312-24-1

CAB TILT PUMP ASSEMBLY MAINTENANCE - CONTINUED

0124 00

PUMP ASSEMBLY REMOVAL - CONTINUED

Remove two locknuts (7) and lockwashers (8) from bottom of pump actuator switch (5) and disconnect two wires (9)

from switch. Discard locknuts and lockwashers.

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste dis-

posal center or safety office for local regulatory guidance. If further information is needed, please con-

tact The Army Environmental Hotline at 1-800-872-3845.

Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning may

result in injury to personnel.

CAUTION

Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings after dis-

connecting. Contamination of hydraulic system could result in equipment failure.

NOTE

Use a drain pan to capture hydraulic fluid in hoses. Dispose of fluid in accordance with local policy and

ordinances. Ensure all spills are cleaned up.

Disconnect two hoses (11) from two elbows (10) at pump (6).

7,8

0124 00-4