REMOVAL - TM-9-2320-312-24-10716

TM 9-2320-312-24-1

CAB TILT LATCH REPLACEMENT - CONTINUED

0121 00

REMOVAL

Tilt cab (TM 9-2320-312-10).

Place battery disconnect switch in OFF position.

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal

center or safety office for local regulatory guidance. If further information is needed, please contact The

Army Environmental Hotline at 1-800-872-3845.

CAUTION

Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings after dis-

connecting. Contamination of hydraulic system could result in equipment failure.

NOTE

Use a drain pan to capture hydraulic fluid in hose. Dispose of hydraulic fluid in accordance with local policy

and ordinances. Ensure all spills are cleaned up.

Disconnect hydraulic hose (3) from latch (4).

CAUTION

Failure to mark location of cab latch on frame bracket could cause latch to be incorrectly installed. Damage

to cab or latch could result if cab is lowered onto an improperly located latch.

Place witness marks to mark location of latch (4) at frame bracket (6). Remove four nuts (5), screws (2), washers (1),

and latch from frame bracket.

0121 00-2