 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
ALTERNATOR REPLACEMENT - CONTINUED
0090 00
REMOVAL
NOTE
Tag wires and cables to ensure correct installation.
Remove tiedown straps as required and discard. Use new tiedown straps on installation.
Terminals are coated with insulation and paint. Remove insulation and paint for access to terminals.
1.
Remove locknut (3), lockwasher (4), and disconnect wire (5) from terminal stud of voltage regulator (2). Discard lock-
nut and lockwasher.
2.
Along right side of alternator (1), remove screw (18), lockwasher (19), washer (20), and ground cable (21) from alterna-
tor GND. Discard lockwasher.
3.
Remove nut, lockwasher, 12-volt cable (6), and two washers from 12-volt terminal stud. Discard lockwasher.
4.
Remove nut, lockwasher, 24-volt cable (7), and two washers from 24-volt terminal stud. Discard lockwasher.
5.
Remove nut (8) and bolt (9) to separate tensioner arm (12) from top of alternator (1).
WARNING
Alternator weighs approximately 50 lb (23 kg). Assistance is required to safety replace alternator.
CAUTION
When removing alternator from vehicle, use care to avoid damaging air conditioner lines and fittings.
NOTE
It may be necessary to loosen screw from tensioner arm at engine.
6.
Remove two locknuts (15), washers (16), bolts (17), and alternator (1) from alternator bracket (13). Discard locknuts.
6
5
3,4
7
8,9
2
10
11
1
12
21
13
18,19,20
15
16,17
14
0090 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals