 |
|||
|
|
|||
|
Page Title:
1A FUSE AND FUSE HOLDER REMOVAL |
|
||
| ||||||||||
|
|
 TM 9-2320-312-24-1
ETHER COLD START SYSTEM MAINTENANCE - CONTINUED
0077 00
1A FUSE AND FUSE HOLDER REMOVAL
WARNING
Ether fuel is extremely flammable and toxic. DO NOT smoke and make sure you are in a well-ventilated
area away from heat, open flames or sparks. Wear eye protection. Avoid contact with skin and eyes and
avoid breathing ether fumes. If fluid enters or fumes irritate the eyes, wash immediately with large quantities
of clean water for 15 minutes. Seek medical attention immediately if ether is inhaled or causes eye irritation.
Failure to follow this warning may cause death or serious injury to personnel.
1.
Disconnect connector (15) to open fuse holder (16).
2.
Remove fuse (38).
3.
Remove self-tapping screw (37) and fuse holder (16) from bracket (10).
16
37
38
15
10
1A FUSE AND FUSE HOLDER INSTALLATION
1.
Install fuse holder (16) to bracket (10) with self-tapping screw (37).
2.
Insert fuse (38) in slot in connector (15).
3.
Connect connector (15) to close fuse holder (16).
4.
Place battery disconnect switch in ON position. Lower cab (TM 9-2320-312-10).
END OF WORK PACKAGE
0077 00-11/12 Blank
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals