 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-10
OPERATION UNDER USUAL CONDITIONS - CONTINUED
0005 00
INFLATE TIRE
1.
Remove pneumatic tire inflator-gage (WP 0018 00) from stowage compartment.
INFLATOR-
GAGE
2.
Remove dummy coupling and connect inflator-gage to emergency gladhand (red) at rear of vehicle.
3.
Start engine (WP 0005 00). Push in trailer air supply control on right side of instrument panel.
4.
Remove valve stem cap and connect inflator-gage to valve stem.
VALVE
VALVE
VALVE
STEMS
STEM
STEM CAP
REAR
FRONT
NOTE
Due to speed limitation of vehicle and its load capability, tire manufacturer has authorized a tire inflation of
120 psi (827 kPa).
If inflating rear dual wheels, add air at both valve stems, located approximately 180 degrees apart from each
other.
5.
Add air until 120 psi (827 kPa) pressure is reached.
6.
Remove inflator-gage from valve stem and install valve stem cap.
7.
Pull out trailer air supply control. Shut down engine (WP 0005 00).
0005 00-20
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals