|
| |
TM 9-2320-304-14&P
5-245
Direct Support and General Support Maintenance (Cont)
NOTE
Right and left stow plates are installed the
same. Right side is shown.
(100) Position stow plate (139) on right rear
roller bracket (67) with two
screws (140) and locknuts (141). Do not
tighten screws.
(101) Remove quick release pin (105) and pin (103) from short strut (119).
NOTE
·
Stow plate should be positioned in center of short strut.
·
Make sure slider arm is fully stowed and slider arm handle contacts long strut prior
to tightening two screws.
(102) Position short strut (119) on stow plate (139) in stowed position and make sure handle (115) of
arm assembly (113) contacts long strut (97).
(103) Tighten two screws (140) and locknuts (141) on stow plate (139).
(104) Push down handle (115) and stow arm assembly (113) in forward position.
Change 1
|
