|
| |
TM 9-2320-304-14&P
5-194
Direct Support and General Support Maintenance (Cont)
5-37. LOAD HANDLING SYSTEM (LHS) HOOK ARM CYLINDER REPLACEMENT
(CONT).
WARNING
Hook arm cylinder weighs 210 lbs. (95 kg).
Attach suitable lifting device prior to lifting
to prevent possible injury to personnel.
NOTE
Steps (13) through (16) are for cylinder
adjustment. Adjustment must be completed
before completing installation of cylinders.
Left side shown.
(13) Attach lifting device to left side
cylinder (1).
(14) Adjust cylinders by supporting left side
cylinder (1) using lifting device and
fully retract cylinder rod (15) in
cylinder (1).
(15) Pull cylinder rod (15) out 1.4 in.
(36 mm).
(16) Loosen hex head screw (16) and rotate
rod lug (17) so rod lug bore lines up
with cylinder shaft bore in hook
arm (18). Tighten hex head screw (16).
NOTE
Do step (17) for left side cylinder only.
(17) Install left side cylinder (1) (rod lug
end) with cylinder shaft (2), washer (4),
lockwasher (5), and screw (6) on hook
arm (18) when rod lug (17) bore and
bore in hook arm line up.
(18) Remove lifting device from left side
cylinder (1).
|
