|
| |
TM 9-2320-304-14&P
5-130
Direct Support and General Support Maintenance (Cont)
5-26. COMPRESSION FRAME REPAIR (CONT).
NOTE
·
Tag and mark all hoses prior to
removal.
·
Left side and right side procedures
are the same. Left side is shown.
·
Cap and plug all hoses and tubes
after removal.
·
Disconnect hoses 2588, 2888, and
2889 on the right side.
(2) Disconnect hoses 2887 (7), 2666 (8), and
2890 (9) from three adapters (10) at
front of compression frame (11).
(3) Remove three nuts (12),
lockwashers (13), and adapters (10) from
compression frame (11). Discard
lockwashers.
(4) Remove three screws (14),
lockwashers (15), and washers (16) from
diverter manifold (17). Discard
lockwashers.
(5) Remove two nuts (18) and compression
frame tubes (6) from diverter
manifold (17).
(6) Remove two fittings (19) and preformed
packings (20) from diverter
manifold (17). Discard preformed
packings.
(7) Remove two preformed packings (21),
spacers (22), compression rings (23), and
nuts (18) from compression frame
tubes (6). Discard preformed packings.
|
