|
| |
TM 9-2320-304-14&P
5-98
Direct Support and General Support Maintenance (Cont)
5-21. LOAD HANDLING SYSTEM (LHS) RUBBER BUMPER REPLACEMENT (CONT).
b. Installation.
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in a
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
NOTE
Compression frame rubber bumpers
shown. Installation procedure is the same
for all rubber bumpers.
(1) Coat threads of rubber bumpers (1) with
sealing compound.
(2) Install rubber bumpers (1) in
compression frame (2).
(3) Install locknut (3) on rubber
bumpers (1).
c. Follow-on Maintenance. Remove wheel chocks (TM 9-2320-279-10).
END OF TASK
|
