|
| |
TM 9-2320-304-14&P
2-29
Operating Instructions (Cont)
(10) Stop truck when lift hook (9) touches flatrack/FRS.
(11) Set transmission range selector (1) to N (Neutral).
CAUTION
·
Ensure parking brake is not applied during load sequence or damage to equipment
may result.
·
Do not use R (Reverse) to back up truck while hook arm is attached to flatrack or
damage to LHS will occur.
NOTE
·
LHS will only operate when transmission range selector is in N (Neutral).
·
No additional equipment can be stowed on or in FRS during loading/unloading.
Additional equipment could overload LHS due to weight of FRS.
(12) Move joystick (7) to LOAD position to engage lift hook (9) and hook bar (2).
(13) If lift hook (9) fails to engage hook bar (2):
(a) Release joystick (7).
(b) Set transmission range selector (1) to D (Drive), release service brake pedal (3), and move
truck forward just clear of flatrack.
(c) Move joystick (7) to UNLOAD position until lift hook (9) is below level of hook bar (2).
(d) Repeat steps (9) through (12).
Change 1
|
