|
| |
TM 9-2320-304-14&P
2-26
Operating Instructions (Cont)
2-9. LOAD HANDLING SYSTEM (LHS) (CONT).
d. Picking Up a Flatrack/Forward Repair System in Manual Mode.
NOTE
LHS will only operate when transmission range selector is in N (Neutral).
(1) Set transmission range selector (1) to R (Reverse) and back truck up to the flatrack. Stop
approximately 5 ft. (1.5 m) from hook bar (2). Check for overhead obstructions and firmness of
ground.
(2) Apply service brake pedal (3) and set transmission range selector (1) to N (Neutral).
CAUTION
·
To avoid equipment damage, ensure that hook arm cylinders do not complete full
extension while operating at engine speeds above idle.
·
Manual mode is used mainly in event of a failure of automatic control electrical
system and when loading FRS. Greater care must be exercised during operation of
MANUAL mode for correct cycle of events to occur, or damage to equipment may
result.
(3) Put PTO ENGAGE switch (4) in ON position. Make sure indicator light (5) comes on.
(4) Turn hydraulic selector switch (6) to MAN H.A. position.
Change 1
|
