|
| |
TM 9-2320-304-14&P
2-24
Operating Instructions (Cont)
2-9. LOAD HANDLING SYSTEM (LHS) (CONT).
CAUTION
Do not use R (Reverse) to back up truck while hook arm is attached to flatrack or damage to
LHS will occur.
NOTE
·
Engine speed should be set at idle. However, slight increase in engine speed may be
necessary depending on terrain.
·
LHS will only operate when transmission range selector is in N (Neutral).
(11) Set transmission range selector (2) to D (Drive) and release service brake pedal (1).
(12) Set transmission range selector (2) to N (Neutral).
(13) Move joystick (6) to LOAD position momentarily and then to UNLOAD position to let lift
hook (9) disengage from hook bar (10). Repeat step (11) until hook disengages.
(14) Set transmission range selector (2) to D (Drive) and move truck forward approximately 5 ft.
(1.5 m).
(15) Stop truck and set transmission range selector (2) to N (Neutral).
|
