|
| |
TM 9-2320-304-14&P
2-21
Operating Instructions (Cont)
c. Off-Loading Flatrack in Auto Mode.
NOTE
Continued repetitive cycles, approximately nine at rated 26,000 lb. payload, of the load
handling system (LHS) could cause overheating and system will fail to pick up the load.
Allow the hydraulic system to cool. Wait approximately 1 1/2 hours or until the hydraulic
reservoir is cool. The hydraulic reservoir is cool when you can hold your hand on the
reservoir for more than 10 seconds.
(1) Check area for sufficient operating room at front and rear of truck. Check overhead clearance
and ground conditions.
(2) Apply service brake pedal (1) and set transmission range selector (2) to N (Neutral).
CAUTION
Ensure parking brake is not applied during unload sequence or damage to equipment may
result.
(3) Put PTO ENGAGE switch (3) in ON position. Make sure indicator light (4) comes on.
(4) Set hydraulic selector switch (5) to AUTO position.
|
