|
| |
TM 9-2320-304-14&P
2-19
Operating Instructions (Cont)
NOTE
If flatrack is being loaded in soft soil conditions, do steps (a) through (c), then continue with
step (18).
(a) Release joystick (7). Set hydraulic selector switch (6) to MAN H.A. position.
(b) Move joystick (7) to LOAD position until flatrack is approximately 2 ft. (0.61 m) off the
ground. Release joystick.
(c) Set hydraulic selector switch (6) to AUTO position. Resume normal AUTO operations.
NOTE
Engine speed will require increasing and decreasing in the following steps to facilitate
performance.
(18) After flatrack contacts rear rollers (10), increase engine speed to 1,500 to maximum rpm until
flatrack is nearly loaded. Reduce engine speed to idle.
(19) Continue loading until engaged flatrack is fully loaded and LHS NO TRANSIT indicator (9)
goes off.
(20) Release joystick (7).
(21) Pull out PARKING BRAKE control (12).
|
