|
| |
TM 9-2320-304-14&P
4-234.29
Organizational Maintenance Instructions (Cont)
c. Adjustment.
NOTE
Both stow plates and wire ropes are adjusted the same way. Right side shown.
(1)
Remove quick release pin (1) and pin (2) from short strut (3).
NOTE
·
Stow plate should be positioned in center of short strut.
·
Make sure slider arm is fully stowed and slider arm handle contacts long strut prior
to tightening screws.
(2)
Position short strut (3) on stow plate (4) in stowed position and make sure that handle of arm
assembly (5) contacts long strut (6).
(3)
Tighten two screws (7) and locknuts (8) on stow plate (4).
(4)
Make sure wire rope (9) is tight.
d. Follow-on Maintenance:
(1)
Install angled roller (Para 4-47).
(2)
Install horizontal roller (Para 4-46).
(3)
Install rear splash guard (TM 9-2320-279-10).
(4)
Install light bar and brackets (Para 4-43.1).
(5)
Remove wheel chocks (TM 9-2320-279-10).
END OF TASK
Change 1
|
