|
| |
TM 9-2320-304-14&P
4-212.6
Organizational Maintenance Instructions (Cont)
4-45.1 CONTAINER HANDLING UNIT (CHU) REAR LOCK LIMIT SWITCH
REPLACEMENT/ADJUSTMENT (CONT).
NOTE
·
LHS should not move when joystick
is in UNLOAD position.
·
If LHS does not move in UNLOAD
position, go to step (14).
·
If LHS moves in UNLOAD position,
perform Steps (7) through (12).
(7)
Move joystick (1) to UNLOAD position
and check LHS for movement.
(8)
Position container lock (6) in locked position and install pin (5) and lock pin (4).
(9)
Remove two screws (8) from lock limit switch (9).
WARNING
Give off harmful vapors, and are harmful to skin and clothing. To avoid injury or death,
keep away from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
(10)
Apply sealing compound to threads of two screws (8).
(11)
Position lock limit switch (9) with two screws (8) on slider (3).
NOTE
Lock limit switch is properly adjusted when lever is depressed and lock limit switch makes
an audible click.
(12)
Position lock limit switch (9) against container lock (6) until audible click is heard, then tighten
two screws (8).
(13)
Repeat step (7) to check LHS for movement.
Change 1
|
