|
| |
TM 9-2320-304-14&P
4-159
Organizational Maintenance Instructions (Cont)
(c) Insert new terminal (5) in locating
hole of crimp tool using the proper
hole according to gage of wire (1).
(d) Slide wire seal (2) down to end of
insulation (3) on wire (1).
NOTE
Wire and seal should be positioned so
larger wings of terminal will crimp around
insulation and smaller wings will crimp
around exposed bare wire.
(e) Position wire (1) on terminal (3).
(f) Press handles of crimp tool
together until ratchet releases and
crimp is complete.
(g) Push new terminal (3) and wire (1)
through connector (4) until seated.
(h) Install two secondary locks (5) on
connector (4).
(i) Connect connector (4).
g. Follow-on Maintenance.
(1) Connect batteries (TM 9-2320-279-20).
(2) Remove wheel chocks
(TM 9-2320-279-10).
END OF TASK
|
