|
| |
Malfunction
Test or Inspection
Corrective Action
TM 9-2320-304-14&P
4-118
Organizational Maintenance Instructions (Cont)
4-18. TROUBLESHOOTING INSTRUCTIONS (CONT).
Table 4-3. Load Handling System (LHS) Troubleshooting (CONT)
LOAD HANDLING SYSTEM (LHS) (CONT)
15. MAIN FRAME DOES NOT LOAD IN MANUAL MODE (CONT).
WARNING
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive
electrical circuits, a direct short may result. Damage to equipment and injury or death to
personnel may occur.
NOTE
Only remove center screw on engine side of LHS control box cover.
Step 2. Check for 22 to 28 Vdc at main frame down directional control (DC) valve harness
connector terminal 2 with ENGINE switch ON, hydraulic selector switch in MAN M.F.
position and joystick in LOAD position.
If Vdc measurement is below specification, go to Step 3. of this Fault.
If there are 22 to 28 Vdc, go to Step 8. of this Fault.
|
